The only part that may need periodic replacement is the spring guide. Depending on the ammo used? I was shooting Aguila SSS (60 grain!) in my...
Granny, Have you tried a 6 o'clock hold on the target?
I keep thinking someone with a 3D printer could be my new best friend if they would crank out a few guide rods... It would be a simple piece to make...
First things first. The magazine lips usually cause this problem. Other threads here...
About that big. I made this one from a nail. It took a few tries, of course. There is no reasonable way to measure the hole and taper, so just make...
dress the sharp edge of the slide first?
I used a "safe-one-side" jewler's file to open up the rear notch some. Front blade is painted neon orange (acrylic) and the combination works well.
JB Weld? I dunno about that. I's use a spot of red locktite - applied at the range so I could verify center. The other option - the more traditional...
I think there needs to be something on the right side to secure the safety itself. But I could be wrong about that. Easy enough to try it and see...
It comes apart just about like any 1911. Going back together make sure of the main spring placement on the sear. It's easy to get it misaligned.
Not at all! Find a box and see for yourself.
I couldn't care less about Browning's supposed warranty. I had called their customer service line and was informed that they had no repair parts in...
Which models have the aluminum frame? I have one already, but would like to buy a couple more. Just don't want a polymer frame.
I had the same problem with one - loose right side safety. Fixed it by making a new (slightly oversized) pin. I made the pin from a small picture...
Separate names with a comma.